Experimental Investigation of Pressure Development and Flame Characteristics in a Pre-Combustion Chamber

This study contributes to research involving wave rotor combustors by studying the

development of a hot jet issuing from a cylindrical pre-combustion chamber. The pre-chamber was

developed to provide a hot fuel-air mixture as an ignition source to a rectangular combustion

chamber, which models the properties of a wave rotor channel. The pre-combustion chamber in

this study was rebuilt for study and placed in a new housing so that buoyancy effects could be

studied in tandem with other characteristics. The effectiveness of this hot jet is estimated by using

devices and instrumentation to measure properties inside the pre-chamber under many different

conditions. The properties tracked in this study include maximum pressure, the pressure and time

at which an aluminum diaphragm ruptures, and the moment a developed flame reaches a precise

location within the chamber. The pressure is tracked through use of a high-frequency pressure

transducer, the diaphragm rupture moment is captured with a high-speed video camera, and the

flame within the pre-chamber is detected by a custom-built ionization probe. The experimental

apparatus was used in three configurations to study any potential buoyancy effects and utilized

three different gaseous fuels, including a 50%-50% methane-hydrogen blend, pure methane, and

pure hydrogen. Additionally, the equivalence ratio within the pre-chamber was varied from values

of 0.9 to 1.2, and the initial pressure was set to either 1.0, 1.5, or 1.75 atm. In all cases, combustion

was initiated from a spark plug, causing a flame to develop until the diaphragm breaks, releasing

a hot jet of fuel and air from the nozzle inserted into the pre-chamber. In the pressure transducer

tests, it was found that hydrogen produced the highest pressures and fastest rupture times, and

methane produced the lowest pressures and slowest rupture times. The methane-hydrogen blend

provided a middle ground between the two pure fuels. An equivalence ratio of 1.1 consistently

provided the highest pressure values and fastest rupture out of all tested values. It was also found

that the orientation has a noticeable impact on both the pressure development and rupture moment

as higher maximum pressures were achieved when the chamber was laid flat in the “vertical jet”

orientation as compared to when it was stood upright in the “horizontal jet” orientation.

Additionally, increasing the initial pressure strongly increased the maximum developed pressure

but had minimal impact on the rupture moment. The tests done with the ion probe demonstrated

that an equivalence ratio of 1.1 produces a flame that reaches the ion probe faster than an

equivalence ratio of 1.0 for the methane-hydrogen blend. In its current form, the ion probe setup

18

has significant limitations and should continue to be developed for future studies. The properties

analyzed in this study deepen the understanding of the processes that occur within the pre-chamber

and aid in understanding the conditions that may exist in the hot jet produced by it as the nozzle

ruptures. The knowledge gained in the study can also be applied to develop models that can predict

other parameters that are difficult to physically measure.